It’s obviously heavy duty, well made and will last, I do like it and it’ll get used. I do have a few improvements: first, maybe look into 3D printing these, the flexibility may lend itself to easier installation; either make it taller, or make two levels, out of it, the front cupholder impacts the transmission tunnel and I’m going to have to take a sander to the front cup holder and grind a side down and the holder needs to be a bit bigger around to accommodate a koozie around a can, it’s a perfect fit on a naked can; the front side needs trimming (I’ll show on a pic) I wish I would’ve bought a unpainted one and I could’ve trimmed the metal and had the angle straightened a bit and I wonder about the angle on the mount side, it doesn’t line up well on a 95 F-350 and even the support bracket is a little off, the angle could be a bit more flat; the holder that came with it would really only work on the back holes, furthest forward the 4wd handle obstructs access and the middle impacts the plastic 4wd cover trim too much, the furthest back holes worked, but the screws didn’t want to line up well, the pocket was still impacting the trim. You will need longer screws up top, bright lights under the truck and a tool to line up the cover piece, the rubber and the cup holder Overall I am happy with it, and I’ll end up cussing less during the install than I will over more spilled drinks lol.
Very high quality and sturdy. Make sure you understand when you order it is an aftermarket item. It wont just fit right in and be good to go. Make sure you use long bolts like the description says. I used #10-24 x 2” screws with a washer and bolt underneath the body. I set a light directly under so I could see through the holes to line them up. That will save you a lot of time and frustration. Overall a very high quality item.
It was perfectly what I was wanting and great quality
Easy to install and looks great!!
The fitment could be a little better . The front cup holder wont go all the way down as it contacts the carpet and the inserts are a tad loose.
Thanks for your feedback Ricky. Judging by all the self tappers in the bezel, my guess is this boot has been removed, and likely installed incorrectly resulting in the cup holder leaning to far forward resulting in your cup contacting the carpet. As for the inserts being loose, we are unble to do a press fit due to the variances in the plastic inserts we see. A zip tie on the underside, or even a few pieces of double sided tape will tape care of this issue for you. We apprecite the 3 star review though!